WEBVTT

1
00:00:00.000 --> 00:00:05.000
♪ Music playing ♪

2
00:00:00.000 --> 00:00:09.560
Hi, I'm Tamiko from Graco, and I'm going to show you how to install the Graco Turn2Me

3
00:00:09.560 --> 00:00:13.240
3-in-1 car seat rear-facing with a lower anchor attachment.

4
00:00:13.240 --> 00:00:17.760
The Turn2Me 3-in-1 car seat rotates from rear-facing for a face-to-face connection with baby to

5
00:00:17.760 --> 00:00:20.360
get them in and out of the car with ease.

6
00:00:20.360 --> 00:00:23.180
Before you install, you'll need to know how to use the turn feature.

7
00:00:23.180 --> 00:00:25.799
The turn levers are located underneath each armrest.

8
00:00:25.799 --> 00:00:28.480
You only need to use one to turn the seat.

9
00:00:28.480 --> 00:00:34.959
At the same time, squeeze the blue trigger and the gray lever and rotate the car seat.

10
00:00:34.959 --> 00:00:38.400
You'll hear a click, which means that the seat is secured in position.

11
00:00:38.400 --> 00:00:41.279
Make sure your tether strap is properly stored at one of the storage locations.

12
00:00:41.279 --> 00:00:45.040
It can be at the back of the seat or on the side like it is here.

13
00:00:45.040 --> 00:00:50.680
Next, rotate the car seat to the rear-facing position.

14
00:00:50.680 --> 00:00:53.200
Make sure the arrow is pointing to the blue label to indicate rear-facing.

15
00:00:54.200 --> 00:01:03.639
Next, take out your lower anchor attachments from the storage position.

16
00:01:03.639 --> 00:01:08.800
When you close the door, make sure the leash is on the outside.

17
00:01:08.800 --> 00:01:12.519
Extend the lower anchor strap to its maximum length by pressing the gray button and pulling

18
00:01:12.519 --> 00:01:13.519
the strap.

19
00:01:13.519 --> 00:01:17.120
Now, lay it in the car seat.

20
00:01:17.120 --> 00:01:20.400
Recline the car seat to one of its four recline positions by using the actuator at the back

21
00:01:20.400 --> 00:01:23.800
of the seat.

22
00:01:23.800 --> 00:01:26.919
Place the car seat in the back seat of your vehicle.

23
00:01:26.919 --> 00:01:30.559
Slide it until the car seat touches the back of the vehicle seat.

24
00:01:30.559 --> 00:01:32.860
Ensure that your vehicle is on flat ground.

25
00:01:32.860 --> 00:01:36.279
And also make sure that at least 80% of your base is on the vehicle seat.

26
00:01:36.279 --> 00:01:38.480
Next, check your level indicator.

27
00:01:38.480 --> 00:01:41.879
The bubble should fall within the blue range for rear-facing.

28
00:01:41.879 --> 00:01:46.000
If not, adjust your recline by using the actuator at the back of the seat.

29
00:01:46.000 --> 00:01:52.279
Remove the infant body support.

30
00:01:52.279 --> 00:01:58.120
Open the door by pressing the button at the front of the car seat.

31
00:01:58.120 --> 00:02:02.000
Open the SnugLock lock off by using the gray lever.

32
00:02:02.000 --> 00:02:09.919
Route the lower anchor strap through the rear-facing belt path marked in blue.

33
00:02:09.919 --> 00:02:18.759
Attach the lower anchor connectors to the lower anchors in your vehicle.

34
00:02:18.759 --> 00:02:25.720
Press down on the center of the seat and remove slack by pulling on the free end of the strap.

35
00:02:25.720 --> 00:02:33.479
You may need to feed the free end of the strap back through the belt path for more leverage.

36
00:02:33.479 --> 00:02:37.440
Close the SnugLock lock off.

37
00:02:37.440 --> 00:02:41.080
Close the door.

38
00:02:41.080 --> 00:02:42.919
And then test for tightness.

39
00:02:42.919 --> 00:02:46.679
Grab at the sides of the seat by the belt path and move the seat side to side and front

40
00:02:46.679 --> 00:02:47.679
to back.

41
00:02:47.679 --> 00:02:50.720
It shouldn't move more than one inch in either direction.

42
00:02:50.720 --> 00:02:57.600
If it does, open the door, open the SnugLock lock off, remove more slack, and close the

43
00:02:57.600 --> 00:03:00.520
SnugLock lock off again.

44
00:03:00.520 --> 00:03:05.320
Also make sure you recheck your level indicator to make sure that it is still within range.

45
00:03:05.320 --> 00:03:06.919
Check for proper harness height.

46
00:03:06.919 --> 00:03:10.119
The harness should be at or just below the child's shoulders for rear-facing mode.

47
00:03:10.119 --> 00:03:13.679
Buckle the child in and attach the chest clip.

48
00:03:13.679 --> 00:03:16.960
Tighten the harness by pulling on the strap at the front of the car seat.

49
00:03:16.960 --> 00:03:19.240
Move the chest clip to armpit level.

50
00:03:19.240 --> 00:03:20.240
Do the pinch test.

51
00:03:20.240 --> 00:03:22.720
You should not be able to pinch any slack at the child's shoulders.